water pump pulley mesurement

Finally, a home for all you 524td oil burners out there.
Post Reply
gadget73
Posts: 607
Joined: Nov 22, 2017 11:30 PM
Location: New Jersey

water pump pulley mesurement

Post by gadget73 »

If any of you fine folks have an extra water pump pulley, could I ask for a measurement? With the pulley sitting on a flat surface, what does it measure from the table to the hole in the center where the pump goes through? The one on my Lincoln is a bit messed up and I don't know if the BMW part is the same. The Ford part is of course unavailable.
kingoftarmace2004
Posts: 131
Joined: Mar 15, 2018 3:34 PM
Location: Fall River Mills

Re: water pump pulley mesurement

Post by kingoftarmace2004 »

it might be the same as the m20. I will try to measure when I get home.-Paul. you want outside lip to center of pumpshaft right?
gadget73
Posts: 607
Joined: Nov 22, 2017 11:30 PM
Location: New Jersey

Re: water pump pulley mesurement

Post by gadget73 »

yeah, total depth from the back edge of the pulley. Just sit it on a table and let me know the measurement from the table to the hole where the pump sits. That should tell me what I want to know. I'm hoping the BMW part is the same as the Ford. My WP pulley was mangled a bit and its got a distinct wobble to it. I think thats why it keeps eating the V belt. I fixed it somewhat but it looks like someone tried to hold it with a pipe wrench and its not quite round anymore.
Post Reply